10528 réponses à ce sujet

[OdorousWo1f]

if you can, connect via Ethernet and see if it pops up then SSH from there to set wifi properly
also your profile picture is lovely

[_lartishow]

Thanks ! I am following the video and before redo all process I spoted à difference between robot. Json of the video and robot file on vigimage:
Do I need to add the serveur information ?

[firened]

the bottom one is correct , serveurs is not required.

[_lartishow]

Thanks, do we have log somewhere ?

[firened]

run `cat /var/log/vigiclient.log`

[pierre]

Or vigiupdate.log

[_lartishow]

Hi !
What does this message mean : No time correction for this robot
Ok this message disappears ! thanks

[OdorousWo1f]

don't know, it just happens. really means nothing it seems
it might be if the robot didn't sync to NTP

[_lartishow]

Hi, is there a way to plug servo on Raspberry to benefit of turret function ?

[firened]

yes it's possible.
do you have more robot parts, like a battery, UPS?

[_lartishow]

yes, but I am using this part on another robot

[firened]

servos have to be powered from a different power source than the raspberry pi, else the pi will crash often.
similar to this

[_lartishow]

Ok, Many thnaks !

[OdorousWo1f]

i have an led diode attached to my robot and it works fine when i push the button on vigibot. i wanna have it flash and not be steady, can i do this just through the configuration?

[Mike118]

Yes check the switch you want ro modify in the remote config and modify START and STOP in order to add EnableX and DisableX

[OdorousWo1f]

no i meant to have it flash on/off when you press the button normally (like 1 second on 1 second off)

[Mike118]

What is the robot you want to configure ? Which switch ? And what gpio do you want to use?

[OdorousWo1f]

Solaris, switch 1 (labeled warning lights) and GPIO 23

[Mike118]

Ok i will try something can you add me in the White list to try some config ?

[OdorousWo1f]

sure hold on
ok try now